In any case, I agree with Peter that something is not right. You can try to change the logical direction before the second drag & drop to see if that helps. Did I understand correctly that the loco changes its direction twice: once when it hits the "in" sensor of the destination, and once again when you use the drag & drop to send it back? If so, then the logical direction of the loco does not match with the direction it should go, and it will stay put. Reading this gives me the impression that you are using drag & drop automatic mode to run the loco. It's like it thinks it's gone somewhere else, and I can't get it to understand it's still in the same block. Problem is, after that, I couldn't get it to move again. I then dragged it back to the the original block, and it changed lights and started going in the wrong direction, but that's just a matter of swapping direction, I assume. I just tried a manual run, and it went to the destination block, and when it hit "In", it stopped and changed the lights over. I managed to get a loco to runs through a route, but no more, and I don't know why.Īs soon as I tell is to go, it puts the name of the loco in the destination block and turns the background yellow. Rocrail isn't the easiest concept to get along with, but I am reading through the wiki and guides.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |